Page 1 of 1

Injection Molding company needed with Foam Filling Capability

Posted: Wed May 29, 2019 4:09 pm
by Marcellakates
An OEM is searching for an injection molding company that has foam filling capabilities to manufacture a couple of products, the largest with the dimensions of 44” x 11” x 7.5”

Currently, the only requirement is that the MAPP Member has foam fill capability and multiple stations of foam filling capability would be desired.

If you have this capability, please send your contact information to Marcella Kates (mkates@mappinc.com) as soon as possible.