MAPP members have access to post on the forum and must be logged in to post. Questions? Please contact info@mappinc.com.

Injection Molding company needed with Foam Filling Capability

Post Reply
Marcellakates
Posts: 14
Joined: Wed Feb 21, 2018 9:07 am

Injection Molding company needed with Foam Filling Capability

Post by Marcellakates » Wed May 29, 2019 4:09 pm

An OEM is searching for an injection molding company that has foam filling capabilities to manufacture a couple of products, the largest with the dimensions of 44” x 11” x 7.5”

Currently, the only requirement is that the MAPP Member has foam fill capability and multiple stations of foam filling capability would be desired.

If you have this capability, please send your contact information to Marcella Kates (mkates@mappinc.com) as soon as possible.

Post Reply